Installation manual

OWNER’S MANUAL SUPPLEMENT

CLARION DPX1001.1

Please note that when configuring the DPX1001.1 amplifier, the LOAD

SELECTOR switch must be set in the correct position in order for the

amplifier to function properly.

Please refer to the chart below for specific settings.

SUBWOOFER IMPEDANCE LOAD SELECTOR SWITCH SETTING

2-OHM Bridged Load 1 OHM

4~8-OHM Bridged Load 2-4 OHM

1-OHM Load on each output 1 OHM

2-OHM Load on each output 2-4 OHM

4 OHM Load on each output 2-4 OHM

If you need further assistance when configuring the DPX1001.1 please

contact Clarion/UNGO Product Support at 1-800-668-5612 ext. 229