Owner`s manual
8.
TROUBLESHOOTING
Nothing happens Microprocessor malfunction
when buttons are due to noise, etc.
pressed.
Consult your dealer.
1.
Turn the unit off.
2.
Remove all wires attached to the power antenna
lead. Check each wire for possible short circuits
using an ohm meter.
3. Turn the unit back on.
4. Reconnect each amplifier remote wire to the power
antenna lead one by one. If the amplifiers turn off
before all wires are attached, use an external relay
to provide remote power-on voltage (excessive
current required).
Replace with a fuse of the same amperage. If the fuse
blows again, consult your dealer.
Wipe dirt off with a soft cloth dampened with cleaning
alcohol.
Write MP3IWMA files onto disc properly.
Use properly encoded MP3IWMA files.
1. Turn off power, then press the
[RELEASE] button and remove
the DCP.
2. Use a thin rod to hold reset
button depressed (2 sec.).
If the reset button is pressed
when a disc is loaded, please
eject the disc and load it once
again before attempting to play
it.
1.
Turn down sound volume. Function can also be
restored by turning power off and on again.
(Speaker volume is reduced automatically when
the speaker protection circuit operates).
2. If the sound is still muted, consult your dealer.
Replace with a CD without scratches.
Use
IS09660
level 1
,2
or
JOLIET or Romeo file
system.
Use properly encoded MP3IWMA files.
Clean the CD with a soft cloth.
Let dry for about 1 hour with power on.
Use
IS09660
level
1,
2 or JOLIET
or
Romeo file
system.
Incorrect wiring.
Power antenna lead is short
circuited,
or
excessive
current is required for
remotely powering on the
amplifiers
or
power antenna.
DCP or main unit connectors
are dirty.
File system is not correct.
MP3IWMA files are absent
on disc.
The speaker protection circuit
is operating.
CD is heavily scratched/
warped.
Files are not recognized as
MP3IWMA files.
CD is dirty.
Condensation may form on
the internal lens when the car
is parked
in
a humid place.
MP3IWMA files are not
encoded properly.
File system is not correct.
Power does not
turn on.
(No sound)
No
sound when
operating the unit
with amplifiers
or
power antenna
attached.
Sound is
poor
when power is
first turned on.
20
CZ209