User Guide

When your Remote Transmitter’s battery is in need of replacement, you will notice a decrease in
your system’s operating range or a decrease in the brightness of the Transmitter’s LED indicator.
To change the battery, remove the 2 screws at the back of the Transmitter and carefully separate
the top and bottom halves of the Transmitter case.
Insert the new battery, making sure that the positive and negative terminals are positioned
correctly and replace the cover.
Additional Remote Transmitters
Additional Remote Transmitters for your CS150 are available from your Authorized Ungo dealer.
Remote Starting
To Remote Start the System:
1. Be sure the System is not in Valet Mode.
2. Press Button 1.
• The parking lights will turn on.
• The LED will flash rapidly.
• The engine will start and run for the duration of its programmed Run Timer.*
• The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).
Turning on the ignition key then pressing the brake pedal will disengage the CS150 and allow
you to operate and drive your vehicle in a normal manner.
*If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times. If the vehicle fails
to start after a total of 3 times the parking lights will flash 4 times and the doors will lock (if installed).
Shut Down
The following will shut down the engine when it is under Remote Start control:
1. Pressing Button 1.
• After the engine shuts down the doors will lock (if installed).
2. Pressing the Brake Pedal.
3. Opening the Hood.
4. Remote Start Time-Out (completion of the timed run cycle).
Basic Features
CS150 Owner’s Manual - Page 3
Battery Type: 23A
owners_150.qxd 7/26/99 7:27 PM Page 3