User Guide

Remote Transmitter Layout
The Ungo CS150 comes with 2 Remote Transmitters used to control the system’s features. Each
time a transmitter button is pressed, the LED will flash to indicate that a transmission is taking
place.
Button 1 Locks and Unlocks the doors*.
Button 2 activates the system’s auxiliary function (usually used for optional trunk release)*.
Button 3 is used to Remote Start the vehicle. It is also used to shutdown the engine if remote
started.
*optional features
Adding or Deleting Remote Transmitters
The Ungo CS150 has the ability to recognize 2 individual remote transmitters. If the vehicle is
used by multiple drivers, each can have their own Remote Transmitter.
To add a Remote Transmitter:
1. Turn the ignition on, off, on, off, on within 4 seconds.
• The status LED and parking lights will flash once.
2. Press and hold the Valet switch for 2-3 seconds.
• The status LED and parking lights will flash 3 times.
3. Release the program switch.
4. Press Button 3* on each Remote Transmitter.
5. Turn off the ignition.
*Be sure that you press only Button 3. Pressing any other transmitter button will cause the unit to recognize the
individual transmitter buttons incorrectly.
Note: The CS150 will respond to only those remote transmitters learned during this procedure. Any previous remotes
will be deleted.
Battery Replacement
Your Ungo Remote Transmitter uses a 12 volt alkaline battery, which will need to be replaced
from time to time. Under normal conditions, the battery should last for up to a year before it
needs replacement.
Remote Transmitters
Page 2 - CS150 Owner’s Manual
Button 3
Button 1
LED
Button 2
owners_150.qxd 7/26/99 7:27 PM Page 2