User Guide

The Ungo CS150 is a remote controlled car start system. When activated, the CS150 will safely
start your car by remote control, without your key in the ignition. If your vehicle is powered by a
diesel engine, the CS150 will turn on the ignition for 20 seconds prior to starting the engine, in
order for the glow plugs to warm up.
Once the CS150 has started the engine, it will turn on your preset accessories (heater/air
conditioner) to provide you with the maximum comfort when you enter your vehicle. After
activation, the CS150 will allow the vehicle to run for approximately 12 minutes (or 24 minutes if
selected by your installer at the time of installation) before automatically shutting off.
Ungo CS150 System comes with:
• Main Unit - The “brain” of the system.
• 2 - Three Button Remote Transmitters
• Extended Range Receiver - Specifically designed to maximize the operating range of
the Remote transmitters.
• Status LED - Red illuminated indicator that provides system status information.
• Valet / Service Mode Switch - used to disable the remote starting system in case the
vehicle is to be serviced. Optional keyless entry features will still function.
Safety
To provide you with the maximum safety and reliability, the CS150 incorporates the following
safety features:
• Brake Pedal Shutdown - Shuts down the CS150 when the brake pedal is pressed.
• Hood Pin Switch Protection (optional) - Prevents the engine from being started while
the hood is open.
• Valet Mode - Prevents the vehicle from being started when being serviced.
Options
The CS150 Remote Start system also has the capability of controlling the following optional
convenience features:
• Remote Keyless Entry (Door Lock/Unlock)
• Remote Trunk Release
• Window Roll-up
About Your Ungo Convenience System
CS150 Owner’s Manual - Page 1
owners_150.qxd 7/26/99 7:27 PM Page 1