Owner`s manual
5-1. Installation of connectors
2.
When connecting the C-BUS cable, fully insert it. After connection, fix the
connector with a clamper as shown in the figure.
1. When handling the cord, take the following precautionary measures:
•
Avoid
places that heat up such as the engine, the exhaust pipe and the
heater
vent.
• Keep it separate from
the
car's own coiled and connected cords.
• Take care not to place it across the burr edge of the metal sheet.
5-2. Installation of CD Changer Unit
CAUTION--------------------------,
• Set
the
installation selector levers
to
the
same position on both sides.
• When
the
unit is installed below the horizontal position (up
to
15
degrees) the ejected maga-
zine, when left in that position, will drop
due
to
vibrations from the car.
• Adjust
the
installation selector levers into the correct locations. Setting
the
locations incorrectly
or
in
varied
positions will cause skipping.
• Do not
move
the
installation selector
levers
while
the
unit is in use. This will cause
damage
to
the mechanism and the disc.
V:
Vertical
F
5
0
H both sides of
the
unit
°v
Align the installation selector
levers
0 on both sides
of
the
unit with the
"V"
position.
45: Slope
~
H
45° both sides of
the
unit
V
Align the installation selector
levers
0 on both sides
of
the
unit with the
"45°" position.
~
50
°H
both sides
of
the unit
V
H: Horizontal
Align
the
installation selector
levers
0 on both sides
of
the
unit with the "H" position.
• Prior to Installation
1) Before attempting
to
use this unit you must first
remove
the
packing safety lock-pins (3 positions). Store these lock-pins
carefully so they can be used again if needed.
Note:
Reinstall these lock-pins when shipping the unit back for repair.
2) Decide on the installation place and direction.
3) Adjust the installation selector levers
0 to the desired installa-
tion position.
*During shipment from
the
factory, the levers are placed in a
horizontal position.
• Switching the Installation Selection Lever 0
Insert
an
item such
as
a screwdriver
with a fine point
or
the
tip of a ballpoint
({O
pen into the round hole of
the
installation V
450
~
H
selector
lever
0 to switch
to
the position
you need.
5-3. Installation Procedure
1. Use the double seamed hexagonal bolts to fix installation bracket to the unit (on
both sides) in the desired direction of installation.
3.
Remove
the floor carpet and decide on
the
place to install.
Adjust the installation bracket with bolts to suit the place of
installation.
2. Use the wing nut to hold in place the installation bracket with bolt to the installa-
tion bracket, which is attached to
the
unit. Then affix the cushion rubber.
/
5. Unfasten the wing nut and
remove
the unit.
6.
Return
the
floor carpet to its original place. Use a knife
to cut into the carpet where the bolt can be felt, and
allow the bolt
to
protrude from the carpel.
4.
Remove
the separator of the cushion rubber
that is attached to the installation bracket with
bolt and install accordingiy.
7. Align the unit with the bolts and secure it with the wing nuts.
• Horizontal Position
..
..
• Vertical Position
• Suspending Position
..