Operation Manual
iPod Operations
28
CMV1
English
Repeat:
1-track:
•This operation plays back all the tracks
currently selected in a random order.
All:
•This operation plays back all the tracks
currently selected repeatedly.
3.To cancel the shuffle play, perform the same
operation.
• The repeat play cannot be canceled.
Normally, it should be set to the All repeat
play.
Note:
• When performing operations using simple control
mode, do not set the repeat off on the iPod.
Setting iPod simple mode
Use this function if you wish to operate through
your iPod connected to this unit via the USB cable.
∗ The factory default setting is “Off”.
1. Press the [OPTION] button.
2. Turn the [UP/DOWN] knob to select “Simple
Control Mode”.
3. Press the [ENTER] button to select “On” or
“Off”.
• On:
Operations can be made through your iPod.
• Off:
Operations cannot be made through your
iPod.
Notes:
• When performing iPod operations using simple
control mode, make the operations slowly. If
repetitive operations are performed too quickly,
unforseen errors may occur.
• When performing iPod operations using simple
control mode, please do not operate the iPod and
the unit at the same time, otherwise there may be
unexpeted event happened.
• Some iPod models do not support this function.
Consult your nearest Clarion dealer or website to
confirm which models do not support this
function.
Setting iPod Output Format
The iPod output format can be changed.
*
The factory default setting is “
Digital
”.
1. Press the [OPTION] button.
2. Turn the [UP/DOWN] knob to s elect “iPod
Output Format”.
3.Press the [ENTER] button to change the
setting: “Digital” or “Analog”.
• Digital: The iPod will be played normaly.
• Analog: When the iPod is connected with
the iPod cable (incuded in the iPod), it will
be played soundlessly.
Note:
• After the setting, please disconnect and then
connect the iPod again to make the setting
become effective.
• Some iPod video models do not support this
function. Consult your nearest Clarion dealer or
website to confirm which models do not support
this function.
Setting iPod sense
The input audio level of the iPod terminals can be
Changed while the iPod output format is set to
“
Analog
”.
*
The factory default setting is
“Mid”
.
1. Press the [OPTION] button.
2. Turn the [UP/DOWN] knob to select “iPod
Sense”.
3.Press the [ENTER] button.
4. Turn the [UP/DOWN] knob to select “Low”,
“Mid” or “High”.
5. Press the [ENTER] button.
iPod Menu Operation
You can specify the tracks to play by narrowing
the following categories:
1. Press and hold the [MENU] button.
•If press the [MENU] button, it will return to
the previous menu.
2. Turn the [UP/DOWN] knob to select “Music”
or “Video”.
3. Press the [ENTER] button.
4. Turn the [UP/DOWN] knob to select a
category.
● In the Music mode
[Playlists]:
The list of all the Playlists stored in the iPod is
displayed.
[Artists]:
You can narrow the Albums to be list
ed by
specifying the Artist name.
[Albums]:
The list of all the Albums stored in the iPod is
displayed.
[Songs]:
The list of all the Tracks stored in the iPod is
displayed.
[Genres]:
You can narrow the Artists to be listed by
specifying the Genre name.
280PE3260E_EN.book Page 28 Tuesday, March 24, 2009 3:41 PM