Owner`s manual

1.
Insert
the source unit into the cutout
hole until
to the end. (Figure 5)
2. Using the
supply
screws (4 x
30) to secure the source unit. (Figure 5)
3.
Using support strap to secure the source unit on the back side by
supply
M4 nut.
(Figure
5)
Notes:
1.
Some boat
models
require
special
mounting kits for proper
installation.
Consult
your
Clarion
dealer
for
details.
• Remove
CD
mech lock-screw.
•
Stick
Hole block seal
for
hole
of
lock-screw.
4
x
30
Screws
Rubber Gasket
4
x
30 Screws
Figure 5
Support Strap
M4Nut
M4washer
/
Source unit
Q
.
~~:·~~:~~
Stud
~4
washer
Note:
Confirm that the
rubber
gasket is fastened securely to the base
panel.
6)
Cautions on Wiring
1.
Be sure to turn the power off when wiring.
2.
Be
particularly careful
where you route the wires.
Keep them
well
away from the engine, exhaust pipe, etc. Heat may damage the wires.
3.
If
the fuse
should blow, check that the wiring is correct.
If
it is,
replace
the fuse with a new one with the same amperage rating as the original
one.
4.
To
replace
the fuse, open the
lock
on the source unit side, remove the
old
fuse and insert the
new one. (Figure 6)
*
There are various types of fuse cases. Do not
let
the battery side terminal touch other
metal
parts.
Fuse
case
Figure 6
7) Sample
Systems
1
Source
unit
®
2
RCA
extension cable
(sold
separately)
3
4-Channel
power amplifier
4
Front
speakers
5
Rear
speakers
6
Wired
remote
control unit
7
SiriusXM-Connect Vehicle Tuner
8
AUX
CMOS
17