Manualshelf

Owner`s manual

ManualsBrandsClarion ManualsAutomotiveCMD4A
78910111213141516
• Contents
1.
BEFORE STARTING 12
2.
PACKAGE CONTENTS 12
3.
INSTALLATION CAUTIONS 12
4. MAIN UNIT INSTALLATION 13
5.
TUNER MODULE INSTALLATION 14
6. WIRE CONNECTION 15
1.
BEFORE STARTING
1.
This set is exclusively for use
in
vessels with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3.
Be sure to disconnectthe battery" - " terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
Battery
Figure 1
2. PACKAGE CONTENTS
1.
Main Unit 1
2. Tuner Module 1
3.
Owner' manual & Installation Manual
..
1
4. 12-Pin Molex
fm
connector 1
5.
8-Pin DIN 10' Extension Cable 1
6.
Tapping Screw M4 8
7.
Machine Screw M4 2
8.
Rubber Stopper 4
9.
Mounting Bracket.. 1
3.
INSTALLATION CAUTIONS
1.
In order to avoid any interference, do not install the tuner module or control unit
in
the proximity of
the engine compartment.
2.
The use of unauthorized parts can cause permanent damage to the unit.
3.
Always check your wire connections to ensure proper installation before turning on the unit.
4.
Consult with your nearest dealer for proper installation or if common parts need to be used.
Seek assistance if modifications or drilling holes to your vessel is needed.
5.
Do not install the unit where it will be subjected to excessive moisture, dust, dirt, foreign particles
or vibration. Areas of high temperature from the engine, direct sunlight, heater
or
hot air should
also be avoided.
6.
Do
not install the unit
in
a location where it will interfere with the vessel operation, or it will injure the
passengers if there is a sudden or emergency stop.
12 CMS1