Operating Instructions and Installation Instructions

13
CAM1 CAM2 CAM3
Automatic Screen switching using Trigger inputs
8
<Trigger input> or <Trigger signal> is when camera priority is selected by a signal, for example if driver uses
right/left turn signal or reverse gear, the monitor shows connected camera in driving mode.
* Below example is set with TRG1(Reverse gear)=CAM1 / TRG2(Left turn signal)=CAM2 / TRG3(Right turn
signal)=CAM3.
1) If there is a trigger signal input, the connected camera is displayed as full screen and switches back when the
signal switches off.
2) MARKER ADJUSTMENT (Adjusting the bumper position)
- Press [MENU] button five times, and select MARKER ADJUST menu.
- Press [ ] button, and select H / V. (H: horizontal / V: vertical )
- Press [ ] button, and switch marker pattern.
(H = -12 ~ +12, V = -12 ~ +12, Default setting: H = 0, V = 0)
- After 10 seconds, set up screen disappears, and set up finishes.
* If there is no button operation, set up screen disappears even during set up process.