Operating Instructions and Installation Instructions

12
Marker No.
(Pattern)
Camera Install
Height
Vehicle
Width
Ｐ１
Ｐ２
Ｐ３
Ｐ４
Ｐ５
Ｐ６
Ｐ７
２，０００
２，２５０
２，５０ ０
２，７５ ０
３，０００
３，２５０
３，５００
２，５０ ０
２，３００
２，５０ ０
- Press [MENU] button four times, and select MARKER SETUP menu.
- Press [ ] button, and switch marker pattern.
* Distance marker function setting is only possible when MARKER SETUP ON is selected on CAM1, full
screen mode.
ON SCREEN DISTANCE MARKER SETTING
7
MARKER SETUP
ON
OFF
CAM1
In CAM1 full screen,
press [MENU] button.
Select ON/OFF with [ ] button
and then press [ ] button.
• The onscreen distance markers should be considered as a general reference to assist the driver in assessing
the distances depicted on the screen. The distance markers have been designed based on the “CCD camera
installation conditions” listed in the next section, but differences in vehicle design and construction may result
in the actual installation condition or location being different from the conditions listed. In such cases, the
display location should be set at the closest marker No.
• Distance markers cannot be set if non Clarion cameras are used.
Warning
• The markers may not indicate the exact position of the bumper, the vehicle’s width or the distance to the rear.
Use as a reference only.
Caution
MARKER
SELECT
Ｐ１
7m
5m
3m
1m
Bumper position
(From bumper toward rear)
Vehicle width
(Unit：mm)
■ CCD camera installation conditions
(distance marker input conditions)
1) MARKER SELECTION