Owner's Manual
1
5.
Use Velcro with double-sided tape to hold the visor and Transceiver unit if
• necessary. (shown
in
Fig. 2). Detail of using Velcro will be explained as the
followings:
Step 1: Attach the Velcro hook to the visor clip with the double-sided tape
provided.
Step 2: Attach the Velcro loop to the hook.
Step 3: Attach the Transceiver unit to the Velcro loop with the double-sided
tape provided.
6.
Secure the Transceiver unit to a location that is easily accessed by the driver
e.g. sun visor (shown
in
Fig.
3)
and dash board (shown
in
Fig. 4).
7.
Set the left/right channel switch according to the position of driver (see
"Switching left or right channel output" on page 23 for details).
8.
Once the car is started, the Transceiver is powered on immediately.
It
cannot
be turned off as long as the ignition key is turned to ON or ACC position.
Notes:
Check that the location of the Transceiver
is
adequate to pick-up
the
car driver
voice.
• Alternately, user
can
use
the external microphone (optional) that
plug
into the
2.5mm audio jack input for a better voice reception.
....,.+-- BluetootH" Audio/Mobile-phone
'-01"/'\'
Transceiver unit (step
3)
----''7--
Velcro loop
(step
2)
"..---
Velcro
hook
(step
1)
~;;;;;O;~~~
"r=~
~--
Visor clip
Figure
2:
Using Velcro with double-sided tape
8 BLT370