Installation manual

OWNER'S MANUAL
Problem
Audio lacks punch.
Solution
kern wired incorrectly, which causes cancellation of bass frequencies.
k polarity
of wires from amplifier to each speaker as defined by the
! system design.
Problem
Amplifier fuse keeps blowing.
,Solution
I Incorrect wiring or short circuit. Review Installation and check all wiring
connections.
,Problem
I Whining or ticking noise in the audio with engine on.
Solution
Amplifier is picking up alternator noise or radiated noise. Tum down input
gain; move audio cables away from power wires. Check power and ground
connections on amplifier; install
an in-line noise filter on source unit's power
wire; check alternator and/or voltage regulator; test for weak battery or add
water to battery
PRODUCT SPECS
APX400.4
Frequency Response
Signal
NOise Ratio
THD
Input SensitiVity Low Level
Input Sensitivity Speaker Level
Max. Power Output
Cont. Power Output
2-0hm Stereo Output
Bndged Power
DimenSions
Current Consumption @ Max Power Output
20Hz - 20kHz
>95db
.05% all channels dnven
250mV - 2.5V
500mV - 5V
380w (190 x
2)
200w (50w x4) @.08% THD
90 x 4 @ .8% THD
190
x2@.8%THD
21/8" H x 81/4" W x 12" L
46A @ 380 Watts
15