Owner`s manual

HX-D1 11
Radio Operations
When you are in the step tuning mode, the fre-
quency changes one step at a time. In quick tun-
ing mode, you can quickly tune the desired fre-
quency.
1. Press
[
BAND
]
button and select the desired
band (FM or AM).
∗ If “MANU” is not lit in the display, press and
hold
[
BAND
]
button for 1 second or longer.
“MANU” is lit in the display and manual tuning
is now available.
2. Tune into a station.
● Quick tuning:
Press and hold the
[a]
button or
[d]
button
for 1 second or longer to tune in a station.
● Step tuning:
Press the
[a]
button or
[d]
button to manu-
ally tune in a station.
Recalling a preset station
A total of 24 preset positions (6-FM1, 6-FM2, 6-
FM3, 6-AM) exists to store individual radio sta-
tions in memory. Pressing the corresponding
[
DI-
RECT
]
button recalls the stored radio frequency
automatically.
1. Press
[
BAND
]
button and select the desired
band (FM or AM).
2. Press the corresponding
[
DIRECT
]
button to
recall the stored station.
∗ Press and hold one of
[
DIRECT
]
buttons for 2
seconds or longer to store that station into pre-
set memory.
Manual memory
1. Select the desired station with seek tuning,
manual tuning or preset tuning.
2. Press and hold one of
[
DIRECT
]
buttons for
2 seconds or longer to store the current sta-
tion into preset memory.
Auto store
Auto store is a function for storing up to 6 sta-
tions that are automatically tuned in sequentially.
If 6 receivable stations cannot be received, a pre-
viously stored station remains unoverwritten at
the memory position.
1. Press
[
BAND
]
button and select the desired
band (FM or AM).
2. Press and hold
[
SCN
]
button for 2 seconds
or longer. The stations with good reception are
stored automatically to the preset channels.
∗ If auto store is performed in the FM bands, the
stations are stored in FM3 even if FM1 or FM2
was chosen for storing stations.
Preset scan
Preset scan receives the stations stored in pre-
set memory in order. This function is useful when
searching for a desired station in memory.
1. Press
[
SCN
]
button.
2. When a desired station is tuned in, press
[
SCN
]
button again to continue receiving that
station.
Note:
• Be careful not to press and hold [SCN] button for
2 seconds or longer, otherwise the auto store func-
tion is engaged and the unit starts storing stations.
Turning on and off the FM diversity
system
The FM diversity system automatically switches
to the antenna that receives an FM broadcast
with a stronger reception signal.
If two antennas are connected, set the FM diver-
sity system to ON; if one antenna is connected,
set it to OFF.
∗ The factory default setting is “OFF”. Setting this
system to the incorrect position results in noise.
1. Press the [BAND] button to receive an FM
broadcast.
2. Press the [DIRECT] button 5 while holding
the [BAND] button.
After having shown the indication “FM DIVER”
in the display, switch the FM diversity system
to show the indication “ON” or “OFF” in the
display.