Owner`s manual

HX-D1 9
Basic Operations
●To adjust the treble
1. After having let the knob come out in step 1,
pull it out further with your fingers.
2. Rotating the [BASS] knob clockwise en-
hances the treble; rotating it counterclockwise
attenuates the treble.
∗ When setting to the center position, the knob
is clicked in position.
Notes:
• When pulling out the knob, you feel a little difficult
to do it.
• Pull out the knob gently. Pulling out the knob
strongly let it be removed from the unit.
• After adjustment, push the knob to store in posi-
tion.
Adjusting the balance
1. Pull out the [VOL] knob.
2. Rotating the [VOL] knob clockwise empha-
sizes the sound coming from the right speaker;
rotating it counterclockwise emphasizes the
sound coming from the left speaker.
∗ After adjustment, push the knob to store in po-
sition.
∗ When setting to the center position, the knob
is clicked in position.
Adjusting the fader
Rotating the [FAD] knob clockwise emphasizes
the sound coming from the front speakers; rotat-
ing it counterclockwise emphasizes the sound
coming from the rear speakers.
∗ When setting to the center position, the knob is
clicked in position.
Setting the clock
Note:
• The time is displayed in the 12-hour clock system.
The clock times in the morning are indicated by
attaching the word “AM”; the clock times in the
afternoon and evening are indicated by attaching
the word “PM”.
1. Press the [DISP] button.
The unit enters the clock display mode.
Note:
• You cannot set the clock when it is displayed with
only the ignition on. If you drain or remove car’s
battery or take out this unit, the clock is reset. While
setting the clock , if another button or operation is
selected, the clock set mode is canceled.
2. Press and hold the [DISP] button for 2 sec-
onds or longer to enter the clock set mode.
3. Press the [a] button or [d] button to select
the hour or the minute.
To set the hour, press the [a] button.
To set the minute, press the [d] button.
4. Press the [DISP] button to store the time into
memory.
∗ To let the time display being usually shown, do
it according to the procedure described in the
next section “Switching the display”.
Switching the display
1. Press the [DISP] button to select the desired
display.
Each time you press the [DISP] button, the
display switches in the following order:
(Radio mode)
(CD mode, CD/MD changer mode)
∗ To turn off the display indication, press the [DISP]
button and the [DIRECT] button 4 at the same time.
Note:
• While the display indication is turned off, only the
[
QQ
QQ
Q
] button and the power switch can be used. To
return to the original state, press the [DISP] but-
ton again or turn off the power.
• Track number/play time display
• Title display
• Clock display
While in the CD/MD changer mode,
press and hold the [DISP] button for
about 2 seconds or longer to show the
disc number/track number display.
• Clock display
• Main display