Owner`s manual

8 HX-D1
5. OPERATIONS
Basic Operations
Note: Be sure to read this chapter referring to the front diagrams of
chapter “3. CONTROLS” on page 5 (unfold).
About the system check function
The CeNET system used in this unit adopts the
system check function. The system check indi-
cations are shown in the following cases. Only
when wiring connections have been made and
the power is turned on the first time, this function
checks the pieces of equipment connected.
• when the power is turned on soon after the unit
is installed.
• when a piece of external equipment is con-
nected or removed.
• when the power source supply is interrupted
for a long period of time for the sake of battery
exchange.
• when the reset button is pressed.
1. Rotate the [VOL] knob clockwise until a click
is heard.
The system check is performed and the indi-
cation is shown in the display in a sequential
manner:
“SYTEM”➜“CHECK”➜“Push”➜“Func”
2. When the [FUNC] button is pressed, the indi-
cation “CHECKING” is shown and the display
shows any of the indications shown in the ra-
dio mode.
Note:
• When the connection cable between this unit and
external equipment is exchanged for a digital op-
tical fiber cable or when the digital optical fiber
cable is removed from the unit to return to the ana-
log input from the digital input, press the [FUNC]
button to execute the system check while the
[DIRECT] buttons 1 and 6 are kept pressed.
Turning on/off the power
Note:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car’s bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
1. Rotate the [VOL] knob clockwise until a click
is heard.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. To turn off the power, rotate the [VOL] knob
counterclockwise until a click is heard.
Selecting a mode
1. Press [FUNC] button to change the mode of
operation.
2. Each time you press [FUNC] button, the mode
of operation changes in the following order:
Radio mode ➜ CD mode ➜ CD changer mode
➜ MD changer mode ➜ AUX mode ➜ Radio
mode...
∗ External equipment not connected with CeNET
is not displayed.
The indication “NO DISC” is shown when no
disc is loaded in the CD mode. While no maga-
zine is loaded in the CD changer mode, the
indication “NO MAG” is shown in the display.
Adjusting the volume
Turning the [VOL] knob clockwise increases the
volume; turning it counterclockwise decreases
the volume.
Adjusting the tone
Push the [BASS] knob to come out.
●To adjust the bass
Rotating the [BASS] knob clockwise enhances
the bass; rotating it counterclockwise attenuates
the bass.
∗ When setting to the center position, the knob is
clicked in position.
<View from above>
The knob comes out
<When adjusting
the bass>
Pull out the knob
with your fingers
<When adjusting
the treble>
Push the knob
being stored.