Owner`s manual
HX-D1 4HX-D1 316 HX-D1
2. PRECAUTIONS
1. When the inside of the car is very cold and
the player is used soon after switching on
the heater moisture may form on the disc or
the optical parts of the player and proper
playback may not be possible. If moisture
forms on the disc, wipe it off with a soft cloth.
If moisture forms on the optical parts of the
player, do not use the player for about one
hour. The condensation will disappear natu-
rally allowing normal operation.
2. Driving on extremely bumpy roads which
cause severe vibration may cause the sound
to skip.
3. When the auto antenna cord is connected
to the car auto antenna cord, when the unit
is switched to the radio mode (or the TV
mode), the antenna is extended automati-
cally. If the car is in a narrow space, the an-
tenna may strike something, so be careful.
4. This unit uses a precision mechanism. Even
in the event that trouble arises, never open
the case, disassemble the unit, or lubricate
the rotating parts.
Bottom View of Source Unit
INFORMATION FOR USERS:
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BY THE MANU-
FACTURER WILL VOID THE WARRANTY .
Use only compact discs bearing the
mark or mark.
Do not play heart-shaped, octagonal, or other specially shaped compact discs.
Handling Compact Discs
Handling
• New discs may have some roughness around
the edges. If such discs are used, the player
may not work or the sound may skip. Use a
ball-point pen or the like to remove any rough-
ness from the edge of the disc.
Ball-point pen
Roughness
• Never stick labels on the surface of the com-
pact disc or mark the surface with a pencil or
pen.
• Never play a compact disc with any cello-
phane tape or other glue on it or with peeling
off marks. If you try to play such a compact
disc, you may not be able to get it back out of
the CD player or it may damage the CD
player.
• Do not use compact discs that have large
scratches, are misshapen, cracked, etc. Use
of such discs may cause misoperation or
damage.
• To remove a compact disc from its storage
case, press down on the center of the case
and lift the disc out, holding it carefully by
the edges.
• Do not use commercially available CD pro-
tection sheets or discs equipped with stabi-
lizers, etc. These may damage the disc or
cause breakdown of the internal mechanism.
Storage
• Do not expose compact discs to direct sun-
light or any heat source.
• Do not expose compact discs to excess hu-
midity or dust.
• Do not expose compact discs to direct heat
from heaters.
Cleaning
• To remove fingermarks and dust, use a soft
cloth and wipe in a straight line from the cen-
ter of the compact disc to the circumference.
• Do not use any solvents, such as commer-
cially available cleaners, anti-static spray or
thinner to clean compact discs.
• After using special compact disc cleaner, let
the compact disc dry off well before playing
it.
Be sure to unfold and read the next page.
Adout the registered marks etc.
, HDCD
®
, High Definition Compatible
Digital
®
and Pacific Microsonics™ are either
registered trademarks or trademarks of pacific
Microsonics, Inc. in the united States and/or
other countries.
HDCD system manufactured under license
fron Pacific Microsonics, Inc. This product is
covered by one or more of the following: In the
USA: 5,479,168, 5,638,074, 5,640,161
5,808,574, 5,838,274, 5,854,600, 5,864,311,
5,872,531, and in Australia:669114. Other pat-
ents pending.
7. TROUBLESHOOTING
Power does not
turn on.
(No sound is
produced.)
Nothing happens
when buttons are
pressed.
Display is not
accurate.
Compact disc
cannot be loaded.
Sound skips or is
noisy.
Sound is bad
directly after
power is turned
on.
Problem
Fuse is blown.
Incorrect wiring.
The microprocessor has
malfunctioned due to noise,
etc.
Another compact disc is
already loaded.
Compact disc is dirty.
Compact disc is heavily
scratched or warped.
Water droplets may form on
the internal lens when the
car is parked in a humid
place.
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
Press the reset button for about 2 seconds with a thin
rod.
Eject the compact disc before loading the new one.
Clean the compact disc with a soft cloth.
Replace with a compact disc with no scratches.
Let dry for about 1 hour with the power on.
Cause Measure
Reset button
GeneralCD