User's Manual

IDSmart UHF Security Gate User Manual

sshuser@freescale ~$ vi outgoing_network.config

 After finish editing the network configuration, type ":wq" to save the configuration file.

 Restart or reboot the equipment.

Always remember the IP Address (OUTGOING_IPADDR) and the Subnet Mask

(OUTGOING_NETMASK) that are changed. When the equipment restarts, the remote access

will no longer available if the network of the notebook or computer are different from the

equipment. If for any reason users can no longer access remotely, the configuration can also

only be changed through accessing the system via console port. The console port can only be

connected through maintenance access of the equipment.

Gateway is used when the equipment communicates across different network. Be sure that

the DEL_GATEWAY and ADD_GATEWAY has the same address.

DNS_SERVER1 and DNS_SERVER2 must be set if the equipment is communicating with

other devices on the network using naming system instead of IP address.

5. Testing the Component of the Equipment

Once the equipment is ready, an illegal item such as an un-borrowed book will trigger

alarm when it is carry through the security gate. If the security gate is not function as expected,

users may switch to debug mode and perform diagnostic on each component during

troubleshooting.

The equipment is remotely accessed using SSH remote access software such as "Putty".

The remote access software should be installed on a computer. To simplify the testing process,

the remote access software can be installed on a notebook. A direct connection can be hooked

up between the notebook and the equipment using Ethernet cable without changing the

network configuration of the equipment (see section 1.4.6 Preparation for Testing the

Equipment).