User's Manual

66 ClareOne
Maintenance
The panel should be used and tested weekly. Testing should include validating
communication between sensors and panel, verifying the alarm functions
properly, validating operation on battery, and checking that communication
networks are operational.
For panel and sensor testing, see System Test, on page 52. For battery
maintenance, see Panel battery specifications and maintenance, on page 11.
Smoke detector considerations
The ClareOne panel does not have any direct wiring options to connect and
monitor smoke detectors. The ClareOne Smoke Sensor uses wireless
connectivity to the panel. Pressing the test button on the smoke sensor will
sound the siren in the sensor as well as alert the panel. All smoke detectors
should be regularly checked and tested. In the case of a low battery in the
smoke sensor, a notification will be sent to the panel. For more details on testing
the smoke sensor, refer to the smoke sensor’s manual.
WARNING: THIS UNIT INCLUDES AN ALARM VERIFICATION FEATURE
THAT WILL RESULT IN A DELAY OF THE SYSTEM ALARM SIGNAL FROM
THE INDICATED CIRCUITS. THE TOTAL DELAY (CONTROL UNIT PLUS
SMOKE DETECTORS) SHALL NOT EXCEED 60 SECONDS. NO OTHER
SMOKE DETECTOR SHALL BE CONNECTED TO THESE CIRCUITS.
AVERTISSEMENT: CET APPAREIL COMPREND UNE FONCTION DE
VÉRIFICATION D'ALARME QUI RÉSULTERA PAR UN RETARD DU SIGNAL
D'ALARME DU SYSTÈME DES CIRCUITS INDIQUÉS. LE RETARD TOTAL
(UNITÉ DE COMMANDE PLUS DÉTECTEURS DE FUMÉE) NE DOIT PAS
DÉPASSER 60 SECONDES. AUCUN AUTRE DÉTECTEUR DE FUMÉE NE
SERA CONNU À CES CIRCUITS.