User's Manual

ClareOne 53
Figure 27: System test
To test the panel:
1. Unplug the panel from the wall outlet.
2. Look at the displayed panel state, verify that it is in normal standby mode with
no current alarms.
3. Fault/open one of the paired sensors.
The panel vocalizes that the sensor is not ready, and the faulted sensor is
now marked not ready on the Security page.
4. Access the panel’s System Test page.
Settings > User/Installer Settings > Enter user/installer PIN > System
Test
5. Tap and run the desired test. See following tests list for test definition.