User's Manual

16 ClareOne
4. Scroll and tap to select the desired network, enter the password, and then tap
Ok.
Note: Tap to hide the keyboard.
5. Add the desired sensors. For full sensor configuration and management, see
Sensor Management on page 46.
6. Tap Next to continue in the wizard.
7. Configure the Installer and Master PINs.
Notes
• The Installer PIN must be 5-digits and the Master PIN must be 4-digits.
• If the Master/Installer PINs are lost, the user cannot access
Master/Installer menus or features. Do not forget these codes.
a. Tap Set Installer PIN, and then enter the desired 5-digit PIN.
b. Verify the PIN, and then tap Next.
You are returned to the Set PIN page.
c. Tap Set Master PIN, and then enter the desired 4-digit PIN.
d. Verify the PIN, and then tap Next.
You are returned to the Set PIN page.
e. Tap Next to continue the wizard.
8. Run any desired diagnostic tests, and then tap Next.
Note: Once installation is complete test the panel and sensors. See System
Test on page 52.