User's Manual

ClareOne 7
Installation option 2: Wall mounted
Option 2 uses the included wall mount bracket. The recommended height for
mounting the panel is 48 in. +/- 12 in. based on the comfort level of the end user.
To wall mount the panel:
1. Select a location for the panel that is close to an outlet, and then run a
connection from the 12VDC supply to the selected installation location.
2. Place the mounting bracket against the selected wall location or gang box,
ensuring that the power cable goes through the center of the mounting
bracket.
Note: The cable does not need to go through the mounting bracket if the
power cable does not run through the wall.
3. Using included screws securely attach the bracket to the gang box or wall.
See the methods below.
a. Gang box: Using 2 of the included machine screws, secure the
bracket to the existing gang box.
b. Mounting hole: Mark the locations of the 4 holes in the wall mount
bracket on the wall, be sure to keep the bracket level when marking
the locations. Using a power drill with 5 mm bit, drill a hole at each
location. Insert one of the included wall anchors into each of the 4
holes. Match the wall mount bracket to the anchor locations. Secure
the panel to the wall using the provided screws in the 4 holes.
4. Remove the panel’s back plate by pressing down on the 2 tabs and pulling
the back plate outward.