User's Manual

6 ClareOne
4. Attach the panel’s back cover, gently pressing it into place. Verify that the
tabs are both fully pressed in.
5. Press the sides of the back plate against the back of the panel, making sure
there is no gap between the back plate and the panel.
6. Align the mounting holes in the back of the panel with the stubs on the
kickstand, and then press kickstand to the rear of the panel.
7. Slide the panel down, locking it into place.
8. Plug the opposite end of the power supply into an electrical outlet.
The panel automatically powers up.
Note: Do not connect to a receptacle controlled by a switch.
9. (Optional) The viewing angle of the panel can be adjusted by pressing the
kickstand tab and sliding the base up or down to the desired position, locking
it into place.