User guide

22 HDBaseT 4x4 Matrix Switcher User Guide

Notes

 Disconnect all the HDBaseT cables before sending command EDIDUpgrade[X].

 In above commands, the [ ] symbols are for easier reading and do not need to be

typed in the actual operation.

 Remember to end the commands with the ending symbols “.” and “;”.

 Type the command carefully. It is case-sensitive.

Control the HDBaseT 4x4 matrix switcher

To control the HDBaseT 4x4 matrix switcher, connect the female 9 pin of the RS232

port to the PC’s RS232 port.

– or –

Connect any of the HDBaseT receiver’s RS232 port with PC (the RS232 command

transmits to the switcher via the twisted pair).

Figure 10: Control the matrix switcher from PC

Figure 11: Control the matrix switcher from remote PC

Rx receiver