User guide

HDMI 4x4 Matrix Switcher User Guide 3
Rear panel
Figure 2: Rear panel of the HDMI 4x4 switcher
(1) GROUND
Connection point for equipment grounding.
(2) INPUTS
Four HDMI input ports. Connect them to the HDMI ports on the
signal sources.
(3) OUTPUTS
Four HDMI output ports. Connect them to the HDMI ports on the
output source devices.
(4) IR EYE
A .25 in. mono jack for rear connection of IR control.
(5) RS232
The serial port for unit control, 9-pin female connector. Connects
with a control device, such as a PC.
Note: Be sure to fill in the corresponding communication protocol
parameters correctly.
(6) Power input
Connect with the power adaptor. Indicator light is on when the
switcher is powered. Be sure to use the adapter that came with the
unit.
System connection
Usage precautions
 The system should be installed in a clean environment with the property
temperature and humidity controlled.
 All devices should be connected before powering on.
 The Cat5e/Cat6 terminations for HDBaseT devices should be a straight-thru
TIA/EIA T568B standard.