User guide

HDBaseT Extender Set 70m User Guide 3
Figure 2: The HDBaseT Extender Set receiver
(1) IR
IR receiver.
(2) ON
Working status indicator of this device. When the CM-BT10-RX70 is on
and working properly, the green LED blinks.
(3) LINK
HDBaseT link status indicator, green LED. Remains illuminated when
there is a connection.
(4) OUT
The LED remains illuminated when connected with devices that support
HDCP, and the HDCP handshake is working normally. If the devices do
not support HDCP, this green LED blinks.
(5) POWER LED
The red LED illuminates and stays illuminated when power is connected.
(6)HDBT IN
Connects via single Cat5e/Cat6 cable to the HDBaseT port in the
CM-BT10-TX70 transmitter or the CM-MT4410-BT-70 matrix switch.
(7) HDMI OUT:
Connect to the HDMI display device.
(8) IR IN:
Connects to an IR receiver. The IR signal received from this port is
transmitted via HDBaseT to the transmitter unit for use at the source
location.
Note: When an IR receiver connects to this port, the front IR port (1) is
unavailable.
(9) IR OUT:
IR signals received by the CM-BT10-TX70 or CM-MT4410-BT-70 and
sent via HDBaseT to the CM-BT10-RX70 are available for emitter use
from this port.
(10) RS232:
RS232 connector. Supports bi-directional RS232 communication.
(11) 24V DC:
Connects to the power supply. Not required when using PoC supplied by
the CM-BT10-TX70 or CM-MT4410-BT-70.