User guide

2 HDBaseT Extender Set 70m User Guide
Product appearance
Figure 1: The CM-BT10-TX70 transmitter
(1) IR
IR receiver.
(2) ON
Working status indicator of this device. When the CM-BT10-TX70 is on
and working properly, the green LED blinks.
(3) LINK
HDBaseT link status indicator, green LED. It remains illuminated when
the device has a connection.
(4) IN
The LED remains on when connected with devices that support HDCP
and are working normally. If the devices do not support HDCP, this
green LED blinks.
(5) POWER LED
The red LED illuminates and stays on when power is connected.
(6) HDBT OUT
Connects via a single Cat5e/Cat6 cable to the HDBaseT port on the
CM-BT10-RX70 receiver.
(7) HDMI IN:
Connect to the HDMI source device.
(8) IR IN:
Connects to an IR receiver. The IR signal received from this port will be
transmitted via HDBaseT to the transmitter unit for use at the source
location.
Notes
When using a control system such as Clare Controls, Crestron, or URC,
the 3.5 mm male mono to 3.5 mm male stereo adapter cable (included)
must be used. The male mono end connects to the control system; the
male stereo end connects to the CM-BT10-TX70.
When an IR receiver connects to this port, the front IR port (1) is
unavailable.
(9) IR OUT:
IR signals received by the CM-BT10-RX70 and sent via HDBaseT to the
CM-BT10-TX70 are available for emitter use from this port.
(10) RS232:
RS232 connector. Supports bi-directional RS232 communication.
(11) 24V DC:
Connects to the power supply.