Installation guide

2 ClareVision Network Video Recorder Installation Guide
Hard disk installation (optional)
Additional SATA hard disks can be installed in your NVR. Disconnect the power
from the NVR before installing a hard disk drive (HDD). A factory recommended
HDD should be used for this installation.
Up to 8 SATA hard disks can be installed on your NVR.
Tools required: Philips head screwdriver.
To install the hard disk drive into the NVR:
1. Remove the cover from the NVR by unfastening the screws on the back and
side panel.
When installing a SATA hard disk drive, we recommend that the installer wear
anti-static gloves and a grounding wrist-strap.
2. Connect one end of the data cable to the motherboard of the NVR and the
other end to the HDD.
3. Connect the power cable to the HDD.