Instructions / Assembly

Photo 8
Photo 7
Step 7 (optional): Insert the vertical rods on either side
of the screen tent’s door. Remove the Velcro retaining
loop securing the pole to the adjacent wall. Once freed,
install one end of the rod into the other’s end to make it
one long rod. Place the bottom of the rod in the pocket
located at the bottom of the panel directly below where
the rods are mounted. Secure the rod with the Velcro
loop. Repeat on the other side. It is recommended to
use these if any wind is present. (Photos 6 & 7)
Step 8: Install securing stakes on the tent. The stakes
are designed to be used on the inside grommets or the
outside tie downs. If there is little to no wind, stakes
may be used in the eyelet in each corner of the screen
tent. Place the tip of the stake on the inside of the
eyelet and drive it into the ground so the hook catches
the eyelet and holds the tent in place.
If wind is present you must use the outside tie downs.
Secure the tent by tying one end of the provided strings
on each metal loop on the outside of the hub and
staking the other end. (Photo 8)
Photo 5