Operating and installation instructions
23
EN
Description of appliance
2.2 Recommended open-outlet taps
2.2.1 Optional swivel outlets
SMB/ LS
Art.-No. 1100-04100
SME
Art.-No. 1100-04150
BGS
Art.-No.
1100-04300
LS 30
Art.-No. 0010-0055
LS 20
Art.-No. 0010-0054
LS 12
Art.-No. 0010-0052
2. Description of appliance
This instantaneous water heater is intended to provide the economical heating of water suffi-
cient for a single outlet, i.e. handwash basin, and must be connected to a special open-outlet
tap to avoid any overpressure. Appliances with a higher power rating can also be used to
supply a kitchen sink. They will also provide a basic shower when used with a special shower
fitting.
When the hot water tap is opened, the instantaneous water heater switches itself on auto-
matically and heats the water as it passes through the appliance. It is only then that the appli-
ance uses electricity. The temperature increase depends on the flow rate.
2.1 Technical specifications
Type M 3-O M 4-O M 6-O M 7-O
Energy efficiency class A
*)
Capacity Litre 0.2
Max. operating pressure MPa (bar) 0 (0); Open outlet only!
Heating system IES® bare wire heating system
Min. water resistance at 15 °C
1)
cm 1100
Max. water inlet temperature °C 20
Rated voltage 1~ / N / PE 230 V AC 2~ / PE 400 V AC
Rated power kW 3.5 4.4 5.7 6.5
Rated current A 15.2 19.1 24.8 16.3
Required min. cable cross-section mm
2
1.5 2.5 4.0 1.5
Hot water output at ∆t = 25 K
2)
l/min 2.0 2.5 3.3 3.7
Switching on at l/min 1.3 1.8 2.2 2.4
Switching off at l/min 1.0 1.4 1.7 2.0
Approx. weight when filled with water kg 1.5
Protection class IP 25
Marking / Approvals see rating plate
*) The declaration complies with the requirements of the EU regulation No812/2013 being binding as of September 2015.
1) The specific resistance can be asked for at your water distribution company. 2) Temperature increase from e. g. 15 °C to 40 °C.