User Manual
Table Of Contents
- Hydraulic System Variant 260/280
- Contents
- Chapter 1 Overall hydraulic system circuit diagram
- Chapter 2 Function
- Chapter 3 Valve components
- 3.1 Main valve block – without active hydraulic system Hydraulic circuit diagram
- 3.2 Baling chamber service shut-off valve – without active hydraulic system
- 3.3 Lock-up valve unit (734)
- 3.4 Pressure relief valve (754), Baling pressure build-up solenoid valve (Y50) without active hydraulic system
- 3.5 Flow controllers (755, 756)
- 3.6 Rotor cut-out clutch Shut-off tap (627)
- 3.7 ROTO CUT knife support IN/OUT solenoid valve (Y54/Y55)
- 3.8 Main valve block – with active hydraulic system
- Index
- 0299 256.1
At CLAAS KGaA mbH we are constantly improving
our products to reflect the latest technological develop-
ments. For this reason, we may from time to time need
to make changes to diagrams and descriptions in this
documentation which do not reflect products which
have already been delivered and which will not be
implemented on these machines.
Technical data, dimensions and weights are given
as an indication only. Responsibility for errors or
omissions not accepted.
Reproduction or translation of this publication, in
whole or part, is not permitted without the written
consent of the CLAAS KGaA mbH.
All rights under the provision of the Copyright Act
are reserved.
CLAAS KGaA mbH
33426 Harsewinkel
Germany
Our contribution to the environment:
CLAAS have printed this manual
on 100 % chlorine free paper.