User Manual
Table Of Contents
- Hydraulic System Variant 260/280
- Contents
- Chapter 1 Overall hydraulic system circuit diagram
- Chapter 2 Function
- Chapter 3 Valve components
- 3.1 Main valve block – without active hydraulic system Hydraulic circuit diagram
- 3.2 Baling chamber service shut-off valve – without active hydraulic system
- 3.3 Lock-up valve unit (734)
- 3.4 Pressure relief valve (754), Baling pressure build-up solenoid valve (Y50) without active hydraulic system
- 3.5 Flow controllers (755, 756)
- 3.6 Rotor cut-out clutch Shut-off tap (627)
- 3.7 ROTO CUT knife support IN/OUT solenoid valve (Y54/Y55)
- 3.8 Main valve block – with active hydraulic system
- Index
- 0299 256.1
TIC VARIANT 260/280 Hydraulic System
11/04 var-h 53
Key to diagram:
626 Shut-off tap
732-4 Non-return valve
734-1 Lock-up valve unit (non-return valve)
734-2 Lock-up valve unit (non-return valve)
755 Flow controller
756 Flow controller
Y50 Baling pressure solenoid valve
A Consumer port
B Consumer port
P Pump port
T Tank port