User Manual

TIC LEXION 500 Electric System
03/05 Lex-e-02a 2a-3
Description of function:
Starting The safety start switch circuit of this engine is identical with the one used
on the mechanically controlled engines.
The engine controller module (A15) is activated via relay K51 by the
ignition lock (S64). During the starting procedure, the engine controller
module (A15) receives the speed signal from the sensor provided on the
camshaft and starts the injection.
Engine monitoring All sensors relevant for operation and monitoring of the engine are
mounted on the engine wiring loom. Only the water level sensor is
connected to the CLAAS wiring loom.
The engine controller module (A15) transmits the signals for displaying
the engine speed, coolant level and the coolant temperature to the CAB
module (A10) via the CAN bus J1939. The CAN module (A10) converts
this signal to the CLAAS CAN bus, thus allowing display on the terminal.
Engine diagnosis The number of engine errors occurred and the corresponding error codes
can be displayed in the terminal. Further diagnosis is carried out via the
diagnosis plug in the central terminal compartment, using the Caterpillar
diagnosis tool CAT-ET. The display of error codes can also be activated
by the diagnosis LED (D2) after actuating the rocker switch (U22).
Diesel engine speed
adjustment
The diesel engine speed depends on the position of switch S35. Three
positions are possible, i.e. idle speed, half throttle and full throttle.
When third gear is engaged, gearbox switch Z95 cuts the power supply to
the CAB module (A10) and the diesel engine speed is reduced – road
travel (see also diagram 44). The maximum speed which can be achieved
now is country-specific and can be configured using the Claas diagnosis
system CDS.
LEXION
Type
Idle speed
(S35)
Half throttle*
(S35)
Full throttle
at no load
(S35)
20 km/h
(Z95)
25 km/h
(Z95)
510-530 1200 rpm 1500 rpm 2100 rpm 1522 rpm 1903 rpm
540-570 1200 rpm 1500 rpm 2100 rpm 1568 rpm 1960 rpm
580 1200 rpm 1500 rpm 2080 rpm 1781 rpm 2080 rpm
*- Indicated speed valid only for „Front attachment
OFF“.
In case of “Front attachment ON”, the idle
speed rpm value is used.
Note: The speeds specified above apply to wheel-equipped machines.
Other speeds apply to MTS- or steel track-equipped machines.