User Manual

Electric System LEXION Montana 570-520 TIC
41s-2 Lex-e-41s 03/05
41s Axle control system, front attachment control system, Montana 570-520
- with integrated MONTANA control unit (up to serial no. 582 00051, 581 00026; 580 00028)
Key to diagram:
Coordinates
A35 Montana control unit module .............................................. 7-i-18
B91 Axle angle sensor, left ........................................................ 7-j-20
B92 Axle angle sensor, right ...................................................... 7-j-16
B93 Cutting angle sensor.......................................................... 7-e-17
B94 Montana cross levelling sensor ......................................... 8-e-16
B126-1 Axle control system inclination sensor 1
B126-2 Axle control system inclination sensor 2
K66 Montana relay .................................................................... 3-h-20
S93 Parking brake switch.......................................................... 4-h-17
XEa Montana feed rake conveyor connector ............................ 5-g-17
Y110 Raise cutting angle solenoid coil ........................................ 7-f-16
Y111 Lower cutting angle solenoid coil........................................ 7-f-16
Y112 Rotate front attachment to the right solenoid coil ............... 7-f-16
Y113 Rotate front attachment to the left solenoid coil ................. 7-f-16
Y114 Lower axle on left-hand side solenoid coil......................... 7-h-18
Y115 Raise axle on right-hand side solenoid coil ....................... 7-h-18
Y116 Lower axle on right-hand side solenoid coil....................... 7-h-18
Y117 Raise axle on right-hand side solenoid coil ....................... 7-h-18
Y118 Oil quantity increase solenoid coil ..................................... 7-h-18
Measured value table:
Item Component Measured value Remark
B91
B92
B93
B94
Sensor 12 V
0.25 V – 4.75 V
(Pin 1-2)
(Pin 1-3)
Y110
Y111
Y112
Y113
Y114
Y115
Y116
Y117
Y118
Solenoid coil 3.8 A
3.2 Ω
See lettering