CAREase II Professional package CE- IIP User Manual -1-
CONTENT Introduction 1 Notice 2 Parts 3 Product introduction 6 Function introduction 7 Installation instructions 16 Specification 19 Abnormality & Troubleshooting 20 Maintenance 21 -2-
Introduction Thanks for buying and using the CKICOM CAREase System. Easier for you to secure the proper use of this product, be sure to read manual before using. Please keep this manual for future reference.
Installation instructions l Wetness Alarm Receiver/Indicator: Open the bottom, put the four AA size batteries in accordance with the positive and negative direction of the internal insert shown in the battery compartment, close the lid; or take a power transformer.
l Checking mode: The Wetness Alarm Receiver/Indicator device installed or connected properly when the power is placed in a secure and easy to observe and operate location; Pairing the Wetness Sensor / Transmitter device and the Wetness Alarm Receiver/Indicator device, the specific pairing method refer to the Sensor matching function; If the Wetness Sensor / Transmitter and Wetness Sensing Adult Diaper assembly is completed correctly, the Wetness Alarm Receiver/Indicator device will appear on the diaper-shap
Notice: u including this product, use of radio frequency devices, may cause interference on a number of shielding bad medical devices, such as hearing aids and heart pacemakers, etc., before use this product you should consult the instructions of the medical equipment or your doctor. u where flammable, explosive materials or gas production or storage sites, should pay close attention to the use of limited radio frequency devices. If required, you should keep away this product. .
Parts Wetness Sensing Adult Diaper Wetness Sensor/Transmitter -5-
Wetness Alarm Receiver/Indicator Screen of Wetness Alarm Receiver/Indicator -6-
Function introduction This product can achieve the following functions: Monitoring functions Record Time function Display settings feature Buzzer setting function Sensor matching function -7-
1 main menu interface The boot interface of Wetness Alarm Receiver/Indicator device is the main menu interface. In the main menu interface, press function key to switch to other options, the setting key to enter setup interface. Within other function interface, press function key to exit back to the main menu interface directly. The figure below shows the main menu interface.
2 Monitoring functions After the CKICOM CAREase system correct installation is complete, the The Wetness Alarm Receiver/Indicator displays ; wet occurs, the The Wetness Alarm Receiver/Indicator displays , and displays the duration of wet, dome light remain bright red; until the nurses remove the diaper, urine pants pattern disappeared. The figure below shows an example for the wet.
3 Record This product has the record function, can produce correct records in the wet condition, and also can query and display correctly. Press the function button to switch to record, the The Wetness Alarm Receiver/Indicator displays and detailed records.Set key can be used to select the sort type, and use up key and down key to view records. The following diagram shows an example of the Wetness Alarm Receiver/Indicator detail record sort by date.
4 Time function This product has the calendar function, can display the date and time correctly between 01-01-2010 to 31-12-2099, and can set the date, time, time display type(12/24 hour display). Press the function button to switch to time, then the Wetness Alarm Receiver/Indicator displays . With the need to change the settings, press set key to select the time and date, then use up and down key to set. The following diagram shows an example of the time and date.
5 Display setting function This product has the time and date display setting function, able to choose whether to display time or date. Press the function key to switch to the display settings, the wet film show / reception displays , use the set key to switch to the display settings, and use up key and down key to set the next turn.
6 Buzzer setting function This product has a buzzer setting function to choose whether to alarm. Press the function button to switch to the buzzer setting, The Wetness Alarm Receiver/Indicator displays , use the set key to select to change the settings, the up and down key to set the next turn. displayed if the order is not alarm, the case of the ring is . The following diagram shows the ring set interface; can state the main interface, long press the up button (2 seconds), fast open / close the buzzer.
7 Sensor matching function This product has a Wetness Sensor / Transmitter device and the The Wetness Alarm Receiver/Indicator device pair of wireless connectivity, and each Wetness Sensor / Transmitter device are identified by one unique code and only connected to the paired The Wetness Alarm Receiver/Indicator device.
Maintenance 1. Do not wrestling or strong impact. 2. Avoid contact with heat or direct sunlight and water. 3. Do not open the The Wetness Alarm Receiver/Indicator device and the Wetness Sensor / Transmitter device of the shell. 4. A long time when not in use, remove the battery. 5. The Wetness Sensor can not change the battery.
Specifications: The Wetness Alarm Receiver/Indicator(R-110) : Operating voltage: DC/6V (4xAA batteries) Input voltage (external power supply): DC6V/500mA LCD Display: FSTN display Wetness Sensor / Transmitter(T-210): Power supply: lithium 3V battery Continuous working time: Can detect diapers: RF Frequency RF Rception with R-110 built-in CR2032 > About 400 Hours > 100 315MHz >10M Wetness Sensing Adult Diaper(D-310): Size: Medium Size: Waist 27 "~ 42"; Large size: of 43 "to 64"; Total weight: (according t
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Statement according to FCC part 15.21: Modifications not expressly approved by this company could void the user's authority to operate the equipment. Statement according to FCC part 15.