Operation Manual

Page 8 of 18
iii. HOLD BUTTON – Activating the HOLD button in combination with one of
the above TIME or RATIO buttons allows you to lock the default level of
either parameter. When the desired level is set, deactivate the hold button
for continued normal use.
iv. AUTO LOOP BUTTON - Press this button to activate AUTO LOOP function.
Press the IN button to select the start of the loop and OUT point will be
found automatically according to the BPM value. (Note: The length of the
loop is determined by the LOOP SET values (See LOOP SET section later on)
28. MIDI A/B – When the unit is in MIDI mode press this button to switch between player
A/B
29. SGL/CTN BUTTON - This function allows you to choose between single track play or
continuous track play (all tracks in order with no delay between tracks). This function
also operates in RELAY mode. With this button you can also switch auto cue on and off,
by holding the button down for 1 second.
30. TIME BUTTON - The button will switch the time value described in the TIME METER
between ELAPSED playing time, TRACK remaining time and TOTAL remaining time.
31. FX SYNC / LOOP SET
- Use this button to select FX SYNC (Green LED) or LOOP
SET (Red LED) mode.
a. FX SYNC - This is used to select the delay time of an effect to the beat of music.
The beat delay ratios are 1/4, 1/2, 3/4, 1/1, 2/1, and 4/1. To turn off auto beat
sync press and hold button for 1 second.
b. LOOP SET - When the loop set function is activated, select the beat bar of 1/2, 1,
2, 4, 8, 16 (1 bar = 4 beat) at which you would like to end your desired loop.
32. SHIFT BUTTON - Hold the SHIFT button enables to call up a second function.
33. POWER CONNECTOR - This connection is used to connect your main power (use Fig.8
cable provided)
34. POWER BUTTON - This button is used to turn your unit power on and off.
35. RELAY SOCKET – Used to connect a CD player to a mixer with “Fader start” function. It
allows you to start the track by moving the crossfader rather than pressing the
PLAY/PAUSE button.