Operation Manual

Page 7 of 18

24. IN BUTTON - Pressing the IN button sets a CUE POINT without music interruption. This

button also used to set the starting point of a seamless loop.

25. OUT BUTTON - This button is used to set the ending point of a loop. A loop is started by

pressing the IN button to select the starting point and the OUT button to set the loop

ending point. The loop will continue to play until the OUT button is pressed once again.

26. RELOOP BUTTON - If a SEAMLESS LOOP has been made, but the CD player is not

actively in seamless loop mode, pressing the RELOOP button will instantly reactivate the

seamless loop mode. To exit loop, press the out button. RELOOP will appear in the VFD

display when the RELOOP function is available. When in loop mode, hold RELOOP button

(LED: IN/OUT/RELOOP will flash and “OUT EDIT” will be indicated on the VFD. You can

now use the JOG wheel to edit the out point, then press RELOOP button again to exit

editing.

27. EFFECTS AND PARAMETER BUTTONS

a. EFFECTS - The below buttons add effects to the music. The volume and length of

the effects can be controlled by a combination of the PARAMETER BUTTONS and

JOG WHEEL.

i. ECHO BUTTON – This button is used to add an ECHO effect your output

signal.

ii. FLANGER BUTTON – The FLANGER effect distorts the output signal and

creates an effect similar to the frequency phasing in and out of each other.

iii. FILTER BUTTON – The FILTER effect tweaks the original sound to add

different tonal definition.

b. PARAMETERS:

i. TIME BUTTON - (X parameter) You can set the time parameter in one of

two ways. The first is to press the FX SYNC button and select the FX beat

value (see FX SYNC section later on) or by pressing the TIME button and

rotating the JOG WHEEL clockwise to increase the length of the effect or

anti clockwise to decrease the level of the effect.

ii. RATIO BUTTON - (Y parameter) You can set the ratio parameter by

selecting this button and rotating the JOG WHEEL clockwise to increase the

level of the effect or anti-clockwise to decrease the level of the effect

Note: For the above when the JOG WHEEL has stopped moving the ratio will return to the

efault setting.