Operation Manual

Page 8 of 25
21. EFFECTS AND HOLD
a. EFFECTS - The below buttons add effects to the music. The volume and length of
the effects can be controlled by a combination of the PARAMETER BUTTONS and
JOG WHEEL.
i. ECHO – This button is used to add an ECHO effect to your output signal.
ii. FLANGER – The FLANGER effect distorts the output signal and creates an
effect similar to the frequency phasing in and out of each other.
iii. FILTER – The FILTER effect tweaks the original sound to add different tonal
definition.
iv. BRAKE – The BRAKE effect is the both the start speed and stop speed of
the track simulating that of a turntable. The START time is controlled by the
X Parameter and the STOP time is controlled by the Y Parameter.
Depending on which operating mode the player is in determines how the
effect is triggered:
1. When in VINYL mode hold the top of the JOG WHEEL (Note: It is advised
to hold the side of the JOG WHEEL with one hand while doing this as any movement
from the JOG WHEEL at this point will cause the unit to go in to scratch mode)
2. When in CD DJ mode press PLAY/PAUSE button to activate.
b. HOLD – Activating the HOLD button in combination with one of the above TIME or
RATIO buttons allows you to lock the default level of either parameter. When the
desired level is set, deactivate the hold button for continued normal use.
22. CLEAR – Press CLEAR button (LED on) or hold the CLEAR button to select the BANK
buttons you would like to clear.
23. Y PARAMETER – (RATIO parameter) You can set the ratio parameter by selecting this
button and rotating the JOG WHEEL clockwise to increase the level of the effect or anti-
clockwise to decrease the level of the effect Note: For the above when the JOG WHEEL has stopped
moving the ratio will return to the default setting.
24. TIME - The button will switch the time value described in the TIME METER between
ELAPSED playing time and TRACK remaining time.
25. SGL/CTN - This function allows you to choose between single track play or continuous
track play (all tracks in order with no delay between tracks). This function also operates
in RELAY mode. With this button you can also switch auto cue on and off, by holding the
button down for 1 second.