Operation Manual

© 2010
Rear Panel
(33) Mains inlet – IEC connector to connect to mains using the supplied lead
(34) Fuse Holder – 20mm mains fuse holder - please note correct rating when replacing
(35) RETURN L+R – When these 6.3mm jacks are connected to the outputs of an external
processor, the output of the external unit will override the internal digital delay effect for
Vocal mics 1 + 2.
(36) SEND – Mono 6.3mm jack to connect to the input of external processors, sending the
effect mix from Vocal mics 1 + 2.
(37) OUTPUTS BALANCED – Balanced XLR L + R main mix outputs
(38) OUTPUTS UNBALANCED – Unbalanced RCA main mix outputs
(39) BOOTH OUT – RCA outputs governed by BOOTH LEVEL control (30)
(40) REC OUT – High frequency cut/boost for each stereo channel
(41) CHANNEL 4 LINE – RCA L+R inputs for line level source (CD, DVD, MP3, PC etc.)
(this input is switchable with the top panel 3.5mm stereo MP3 input)
(42) CHANNEL 4 PHONO – RCA L+R phono inputs for turntable
(43) CHANNEL 3 LINE – RCA L+R inputs for line level source (CD, DVD, MP3, PC etc.)
(44) CHANNEL 3 CD – RCA L+R inputs for CD player (or other line level source)
(45) Ground (earth) – Screw terminal for grounding equipment to the case of the
CDM8:4 mkV. Attach turntable ground spade connectors here.
(46) CHANNEL 2 LINE – RCA L+R inputs for line level source (CD, DVD, MP3, PC etc.)
(47) CHANNEL 2 CD – RCA L+R inputs for CD player (or other line level source)
(48) CHANNEL 1 LINE – RCA L+R inputs for line level source (CD, DVD, MP3, PC etc.)
(49) CHANNEL 1 PHONO – RCA L+R phono inputs for turntable
(50) REMOTE STARTS – 3.5mm mono jack outputs sending “start” trigger signals from
channel faders 1 to 4 to start play on compatible CD players automatically when the fader
is moved upward from the lowest point.
CONNECTION GUIDE