Technical data

MULTI-TOUCH-MONITOR MTIR-FR02-V1
7
3 Installation
The following guidance must be observed when mounting the device. Failure to do so may result in breakage or
damage to the unit. No warranty claims are accepted for damages caused by not following these instructions
· When mounting the multi-touch-monitor care should be taken not to obstruct the cooling air ventilation of the
monitor. Ventilation openings must be kept clear. Environmental conditions as given in the Technical Data
section of this manual should not be exceeded.
· Do not expose the multi-touch-monitor to direct sun light. Otherwise the LCD might overheat.
· Do not mount the multi-touch-monitor so that it gets twisted. The same is true for it’s mounting fixtures,
· Please use only the specified mounting points to apply mechanical forces.
· This monitor complies to (EMC-directive). requirements for immunity to interference
To achieve optimum immunity a separate earth connection for the housing is recommended.
Observe the Precautions in Chapter
1 of this manual.
3.1 Connections
Touch DVI VGA Power Supply
1. Disconnect your computer and the multi-touch-monitor from the power supply.
2. Connect a VGA- and/or DVI-video-cable (15 pin mini D-SUB / 24 pin DVI) to the video output of your
computer and to the VGA and/or DVI-input of the Multi-Touch-Monitor.
3. Connect a USB cable between the “Touch“ connector of the Multi-Touch-Monitor and a USB port of your
computer.
4. Connect the power lead with the power supply socket of the Multi-Touch-Monitor and a suitably earthed
mains socket.
HINT
Damaged or poorly inserted video or power leads can result in distorted or poor quality images or even damage
to the device itself