Operation Manual

69
Steering mounted controls
EASE OF USE and COMFORT
4
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
Exceeding the programmed
speed
Switching the function off
Operating fault
The programmed speed is cleared
thenreplacedbythreedashes.
Contact a CITROËN dealer or a
qualiedworkshoptohavethesystem
checked.
Flashing of the speed setting
Good practice
In any event, the speed limiter cannot
replace the need to observe speed
limits, nor can it replace the need for
vigilanceonthepartofthedriver.
Alwayspayattentiontotheprole
of the road and sharp acceleration
and stay in complete control of your
vehicle.
Toavoidanyjammingunderthe
pedals:
- ensurethatthematanditsxings
ontheoorarepositionedcorrectly,
- never place one mat on top of
another.
Pressing the accelerator pedal in order
to exceed the programmed speed
will have no effect unless you press
the pedal rmly beyond the point of
resistance.
The limiter is deactivated temporarily
andtheprogrammedspeedashes
accompaniedbyanaudiblesignal.
To return to the limiter function, reduce
your speed to below the programmed
speed.
Thespeedsettingashes:
- following forcing of the accelerator
point of resistance,
- when the limiter cannot prevent an
increase in the vehicle speed due
totheproleoftheroadorona
steep descent,
- intheeventofsharpacceleration.
- Place the switch in position 0 or
switch off the ignition to switch the
systemoff.
The last programmed speed remains in
thememory.