Operation Manual

66
Steering mounted controls
Berlingo2VP_en_Chap04_Ergonomie_ed02-2016
Changing the
programmed speed
Switching the system off
Operating fault
Cancelling the programmed
speed setting
When the vehicle becomes stationary,
after switching off the ignition, the
systemnolongermemorisesaspeed.
There are two methods of memorising
a speed higherthanthepreviousone:
- Place the dial in position 0 or switch
off the ignition to switch everything
off.
Good practice
Without using the accelerator
- Press the SET +button.
Abriefpressincreasesthespeedby1mph(km/h).
A maintained press increases the speed in
stepsof5mph(km/h).
Using the accelerator
- Exceed the memorised speed until
the speed required is reached,
- Press the SET + or SET -button.
To memorise a speed lower than the
previousone:
- Press the SET -button.
A brief press decreases the speed by
1mph(km/h).
A maintained press decreases the
speedinstepsof5mph(km/h).
The programmed speed setting is
clearedandreplacedbythreedashes.
Contact a CITROËN dealer or a
qualiedworkshoptohavethesystem
checked.
When changing the programmed
speed setting by means of a
maintained press, pay attention as
the speed can increase or decrease
rapidly.
Do not use the cruise control on
slipperyroadsorinheavytrafc.
In the event of a steep slope, the cruise
control cannot prevent the vehicle from
exceeding the programmed speed
setting.
In any event, the cruise control cannot
replace the need to observe the speed
limits and the need for vigilance on the
partofthedriver.
Itisadvisabletokeepyourfeetnear
thepedals.
Toavoidanyjammingunderthe
pedals:
- ensurethatthematanditsxings
ontheoorarepositionedcorrectly,
- never place one mat on top of
another.