Operation Manual

48
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Trip recorder zero
reset button
After this operation, if you wish
todisconnectthebattery,lock
thevehicleandwaitforatleastve
minutes, otherwise the zero re-set will
notberegistered.
Engine oil level indicator
Depending on your vehicle's engine,
when the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information.
Oil level
correct
Low oil level
Flashing of "OIL",
linkedwiththe
service warning lamp,
accompanied by an
audible signal and a message in the
screen, indicates a low oil level which
coulddamagetheengine.
Ifthelowoillevelisconrmedbya
checkusingthedipstick,itisessential
thatthelevelistoppedup.
Oil level gauge
fault
Flashing of "OIL--"
indicates a
malfunction of the
engineoillevelindicator.Contact
aCITROËNdealeroraqualied
workshop.
The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
morethan30minutes.
Dipstick
A = maximum, never exceed
this level as a surplus of oil
maydamagetheengine.
Contact a CITROËN dealer
oraqualiedworkshop
withoutdelay.
B = minimum, top up the level
viatheoilllercap,usingthe
grade of oil suited to your
engine.
Lighting dimmer
With the ignition on, press
the button until the zeros
appear.
With the lighting on,
press the button to vary
the brightness of the
instrumentsandcontrols.
When the lighting reaches
the minimum
(or maximum) setting, release the
button then press it again to increase
(orreduce)thebrightness.
As soon as the lighting is of the
requiredbrightness,releasethebutton.
Zero reset
YourCITROËNdealeroraqualied
workshopcarriesoutthisoperation
aftereachservice.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
- switch off the ignition,
- press and hold the trip recorder
reset button,
- switchontheignition.
Thedisplaybeginsacountdown.
When the display shows "=0", release
thebutton;thespannerdisappears.