Operation Manual

Audio and Telematics
280
Berlingo2VP_en_Chap10b_RD45_ed02-2016
Thetablebelowgivesanswerstothemostfrequentlyaskedquestionsonyouraudiosystem.
QUESTION ANSWER SOLUTION
With the engine off, the
audio system switches off
afterafewminutesofuse.
When the engine is switched off, the audio system operating time
dependsonthestateofchargeofthebattery.
Theswitch-offisnormal:theaudioequipmentswitchestoeconomy
mode and switches off to prevent discharging of the vehicle's
battery.
Start the vehicle's engine to increase the battery
charge.
The message "the audio
system is overheated"
appearsonthedisplay.
In order to protect the installation if the surrounding temperature
is too high, the audio system switches to an automatic thermal
protection mode leading to a reduction in volume or CD play
stopping.
Switch the audio system off for a few minutes to
allowthesystemtocool.
Frequentlyaskedquestions
QUESTION ANSWER SOLUTION
There is a difference in
sound quality between the
different audio sources
(radio,CD...).
For optimum sound quality, the audio settings (Volume, Bass,
Treble, Ambience, Loudness) can be adapted to the different sound
sources, which may result in audible differences when changing
source(radio,CD...).
Checkthattheaudiosettings(Volume,Bass,
Treble, Ambience, Loudness) are adapted to
thesourceslistenedto.Itisadvisabletoset
the audio functions (Bass, Treble, Front-Rear
Balance, Left-Right Balance) to the middle
position, select the musical ambience "None"
and set the loudness correction to the "Active"
position in CD mode or to the "Inactive" position
inradiomode.
Radio