Operation Manual

185
QUICK HELP
8
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
Changing a bulb
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
Rear lamps
This procedure requires the use of
the spanner supplied with the tools for
changingawheel.
Whenretting,takecareto
reposition the tabs and the wiring
correctly to avoid trapping the
wiring.
After changing the rear direction
indicator bulb, the reinitialisation time is
above2minutes.
- Move aside the 4 tabs then extract
thebulbholder.
- Remove the faulty bulb by
pressing it lightly while turning it
anticlockwise.
- Changethebulb.
Whenremovingthelampunit:
- with tailgate, pull the lamp unit
towards the centre of the vehicle,
- with hinged doors, pull the lamp
unittowardsyou.
For more information on bulbs, refer to
the"Typesofbulb".
1. Brake lamps / sidelamps
Type B,P21/5W-21/5W
2. Direction indicators
Type B, PY21W - 21W (amber)
3. Reversing lamps
Type B, P21W - 21W
4. Foglamps
Type B, P21W - 21W
High pressure jet washing
When using this type of washing
on stubborn dirt, do not persist on
the headlamps, the other lamps
and their edges to avoid damaging
theircoatingandseals.
Chapter 9, "Changing a wheel"
section.
- Identify the failed bulb, then open
thereardoorsto180°.
Chapter3,"Access"section.
- Removethetwoxingboltsusing
thespannerprovided.
- Pullthelampunitfromtheoutside.
- Holding the lamp, disconnect the
electricalconnector.