Operation Manual

177
QUICK HELP
8
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
Changing a wheel
Berlingo2VP_en_Chap08_Aide-rapide_ed02-2016
FITTING THE WHEEL
TRIM
The tyre valve must be centred in the
wheeltrimcut-out.
Thispositionisessentialforttingthe
wheeltrimcorrectlyonthesteelwheel.
(If the valve is not correctly aligned with
the cut-out, the anti-rotation system
will be in contact with the heads of the
wheelboltsandrisksbeingdamaged
iftheuserpersistsinttingthewheel
triminthisincorrectposition).
- Ensure that all of the clips are
engaged except the last one
(oppositethevalvehole).
- Strikethewheeltrimwiththepalm
of your hand, opposite the valve
intheareaofthelastxingclip
(alwaysinthedirectionofclipping).
- Ensure that the outer edge of
the wheel trim is not deformed or
pushedintothewheel:
● Correct position for the edge of
thewheeltrim.
● Incorrect position for the edge of
thewheeltrim.
Refer to the "Instruments and
controls" section of chapter 3,
"Tyreunder-inationdetection"
part, for recommendations after
changingawheelttedwithatyre
under-inationdetectionsensor.
Refertothe"Identication
markings"sectionofchapter9to
locatethetyrelabel.
6. Refitting the repaired wheel
Thewheelisrettedasdescribedin
step5,notforgettingtoretthewheel
trim.