Operation Manual

163
CHECKS
7
Berlingo2VP_en_Chap07_Verication_ed02-2016
AdBlue
®
Berlingo2VP_en_Chap07_Verication_ed02-2016
DIESEL PRIMING
PUMP
If you run out of fuel, it is necessary to
primethefuelcircuit.
Other HDi engines
- Fillthefueltankwithatleastve
litresofDiesel.
- Squeeze and release the manual
priming pump, under the bonnet,
undertheprotectivecover.
- Operate the starter until the engine
starts.
BlueHDi engine
- Fillthefueltankwithatleastve
litresofDiesel.
- Switch on the ignition (without
startingtheengine).
- Wait around 6 seconds and switch
offtheignition.
- Repeattheoperation10times.
- Operate the starter to run the
engine.
FUEL CUT-OFF
In a serious collision, a mechanism
automatically prevents fuel from
reachingtheengine.
Theashingofthiswarning
lamp is accompanied by a
messageinthescreen.
Checkthatthereisnoodouror
leakageoffueloutsidethevehicleand
re-establishthefuelsupply:
- switch off the ignition
(STOP position),
- removethekey,
- putthekeybackintheignition,
- switchontheignitionandstart.