Troubleshooting guide

ADB Remote Control Guide
3
4
Last
(Returns to last channel viewed)
Power
TV
Set Top Box
DVD
Auxillary Device
(VCR, Stereo, Additional TV, etc.)
Video On Demand
(Lists On-Demand Movies)
Menu
(Main Menu)
DVR
(Digital Video Recorder)
Directional Arrows
(Use to move to information)
OK
(Makes your selection)
Exit
(Returns to Programming)
Volume
Channel
(View next or previous channel)
Info
(Channel Name & Number,
Current Program, etc.)
Last
(Returns to last channel viewed)
Mute
Number Pad
(Enter Channel Numbers,
Passwords, Users, etc.)
Guide
(View Current &
Future Programming)
VCR/DVD/DVR
Controls
VCR/DVD/DVR
Controls
Color Code Chart
Frequently Used Commands
Generally Used Commands
Future Service Commands
Audio
Setting up your Remote Control
Before you can use your Remote Control for additional functions such as your TV or DVD Player, you will
need to insert a programmable code into the Remote by doing either the Quick Search or a Manual Entry. These
codes are located in the Remote Control User’s Guide that was included in the packaging of the Remote Control
and are listed by brand and model of your device.
Quick Search Set-Up
Use the following steps to program your TV into your Remote Control.
1. Turn on your TV.
2. Press the TV button once.
3. Press the RCU SETUP button until the TV button blinks twice.
4. Enter 991 by using the Number Pad. (The TV button should flash two times. If the
TV button emits one long flash, repeat steps 2 through 4.)
5. Press and release the CH + button continuously until your TV turns off.
6. Then press the RCU Setup button once to lock in the code.
7. To make sure your device has been programmed correctly, point the Remote Control at your TV and
press the POWER button to turn on.
8. Try your volume button, channel up and down button and STB Button to make sure your guide comes up.
If these all work, you are set.
TV: _________ DVD: _________ AUX: _________
Device Codes:
RCU
SETUP
1. Is your device programmed into your Remote Control? (If so, continue to step 2. If not, refer
to the above steps in Programming your Remote Control.)
2. Press the button of your selected device (TV, AUD, DVD, AUX, or STB)
3. Press the Power button
4. Your device should now be on
5. Every button that is pressed on the Remote Control will now control your selected device until
another device is activated
Additional Info: Multiple devices can be powered at the same time using the same Remote Control.
If the STB is selected and the power button is pushed both the TV & the Set Top Box will power down, if
the TV is programmed into your Remote Control.
Use the following steps to program your Remote Control.
1. Turn on the device that you wish to program into the Remote Control.
2. Find the 4-digit code found in the Remote Control User’s Guide.
3. Press the button (TV, AUD, DVD, AUX, or STB) on the Remote Control
4. Press the RCU SETUP button until the device button blinks twice.
5. Enter the 4-digit code by using the Number Pad (The selected button should flash two times. If the
selected button emits one long flash, repeat steps 2 through 6.)
6. To make sure your device has been programmed correctly, point the Remote Control at your
device and press the POWER button once.
7. Once you have successfully programmed your device, note the code below for future reference.
8. Repeat process to program another device.
Manual Set-Up
Powering Devices