Troubleshooting guide

Amino Remote Control Guide
1 2
TV
Power
Set Top Box Power
Input Button
Menu
(Main Menu)
DVR Button
(Listing of Recordings)
Directional Arrows
(Use to move to information)
OK
(Makes your selection)
Previous Channel
(Returns to Last Channel)
Volume
Channel
(View next or previous channel)
Info
(Channel Name & Number,
Current Program, etc.)
Subtitles Button
Mute
Number Pad
(Enter Channel Numbers,
Passwords, Users, etc.)
Guide
(View Current &
Future Programming)
DVR
Controls
DVR
Controls
Color Code Chart
Frequently Used Commands
Generally Used Commands
Future Service Commands
Setting up your Remote Control
Before you can use your Remote Control for your TV, you will need to insert a programmable code into the Remote
by doing either the Brand or Auto Search.
Brand Search Set-Up
Use the following steps to program your TV into your Remote Control.
1. Determine the manufacturer of your TV set.
2. Look up the 4-digit manufacturer code located in the Amino Remote Control Guide.
3. Make sure your TV set is turned on.
4. Press and hold the 1 and 3 buttons at the same time on the Remote Control for approximately 3 seconds
until the TV button remains lit, then release both buttons.
5. Enter the 4-digit manufacturer code for your TV set. On each digit entry the TV button will flash. On
entry of the 4th digit the TV button will flash then remain lit.
6. Point the remote control at the TV and press and hold down the TV button on the Remote Control.
7. When the TV turns off, release the button. This may take a few minutes to happen.
8. Press and hold the Text/Shift button and then at the same time the Stop button to finish setting up
the TV control mode.
9. The TV button will go out and now your TV is programmed into the Remote Control. To verify, simply
press the TV button to turn your TV on and off.
Auto Search Set-Up
Use the following steps to program your TV into your Remote Control.
1. Make sure your TV set is turned on.
2. Press and hold the 1 and 3 buttons at the same time on the Remote Control for approximately 3 seconds
until the TV button remains lit, then release both buttons.
3. Point the remote control at the TV and press and hold down the Mute button on the Remote Control.
4. When the TV turns off, release the button. This may take a up to 5 minutes to happen.
8. Press and hold the Text/Shift button and then at the same time the Stop button to finish setting up
the TV control mode.
9. The TV button will go out and now your TV is programmed into the Remote Control. To verify, simply
press the TV button to turn your TV on and off.
Removing TV settings from your Remote Control
If you would like to program a new TV into the Remote Control, you first need to remove the old TV settings.
Use the following steps to remove your TV into your Remote Control.
1. Press and hold the 1 and 6 buttons simultaneously for approximately 3 seconds until the TV button
is lit.
2. Enter the following key sequence in the correct order 9 9 6.
3. The TV settings will be deleted from the Remote Control.
TV: _________
Device Code:
Back Button
Exit
(Returns to Programming)
Text/Shift
Button
Page up & down
Stop Button