Specifications

- 64 -
2.2.7 Paper Detecting Commands
ESC c 3 n
[Function] Selecting the Paper Sensor valid for a Paper-end signal output
[Code] <1B>H<63>H<33>H<n>
[Range] 0≦ｎ 255≦
[Outline] This command selects by which Paper Sensor a Paper-end signal should be output.
Each bit for “n” has the following meaning:
Value
Bit Position
0 1
0 Paper Near-end 1 Disabled Enabled
1 Paper Near-end 2 Disabled Enabled
2 Paper-end Disabled Enabled
3 Paper-end Disabled Enabled
4 Undefined ―― ――
5 Undefined ―― ――
6 Undefined ―― ――
7 Undefined ―― ――
[Caution] This command is valid only for the parallel interface.
[Default] ｎ＝0